chimney-flue-repairA furnace or boiler flue is relatively inexpensive to reline, but it’s extremely costly to reline a fireplace flue because the existing terracotta flue tiles must be removed in order to fit a new liner down the chimney. Other factors like insulating the new chimney liner for wood burners also increase the cost. While some cracked flue tiles can only be repaired by relining the chimney, Chadds Ford Chimney Sweeps can repair many defective fireplace flues for a fraction of the cost of relining the flue with FireGuard.

Masonry chimney flues typically exhibit three distinct types of damage that make the chimney unsafe to use:

A cracked tile can be caused by a variety of factors from the thermal stress of a chimney fire or a lightning strike to a defect when the tile was fired. This problem is typically fixecd by relining the flue with a stainless steel liner, but in some cases we can re-surface the tiles with FireGuard for a fraction of the cost of relining the chimney.

Usually caused by the corrosive effects of oil soot. This problem is best remedied by relining the flue.

This is the most common type of flue damage we encounter. It results when the chimney’s builder uses ordinary mortar, instead of heat resistant refractory mortar, to bond the flue tiles. Fortunately, we are able to economically correct this problem with FireGuard.

The FireGuard system uses a vibrating applicator that is winched through the flue to force a special heat resistant ceramic material into open mortar joints. We are also able to repair some cracked flue tiles with a special applicator that resurfaces the entire flue tile. The FireGuard material has a service temperature that far exceeds the requirements for residential chimney. It creates a solid, smooth, water and acid resistant surface.

While relining the flue with corrugated stainless steel remains our preferred method of repairing a furnace or boiler flue, the FireGuard system can’t be beat for an economical solution when open mortar joints or cracked flue tiles in a fireplace flue require repair.

Today it’s all about true relationships, true partnerships, real communication, great work and measurable results. And OK, a few choice words of praise from our clients.

  • “Extremely knowledgeable, professional and clean. They are not finished yet, as they had to treat my chimney with a chemical to loosen the creosote and will be back on December 20, 2008 to clean it. I was very impressed with two gentlemen who came out to do the work. I have no reason to expect that their work in cleaning the chimney will be any less than their first visit to treat the creosote. I would highly recommend them.”

    Chimney Cleaning
  • “This was my second time using Chadds Ford Chimney Sweep. We had our air ducts, dryer vent and chimney cleaned. Kevin was clean, prompt and efficient. I have white carpeting in the living room, and you would never know they were there cleaning soot and ash!”

    Ducts and Vents Cleaning
  • “The quality of the service was very good. Mr. Knight looked at all four of our chimneys and only recommended that one be cleaned. Although he was running late, he was kind enough to call well in advance and was very professional. We will certainly use him in the future and feel lucky to have found such a great company to work with.”

    Chimney Cleaning
Read More